Instruction manual –
a
Terra-Lun
You are the owner of the model Terra Luna, a high manual grain mill.
It was manufactured for you by artisanal craftmanship.
Before you start the milling, please note the following points:
Mounting
Push the handle into the hole inside of the stainless steel disc. Put
the flat nut (left hand thread) in the hexagonal slot inside of the
grinding stone. Push them together from below to the handle axis and
screw it by turning to the left until the end of the thread. Now put
the washer on the axis and screw the clamping screw on it by turning
to the right, until the handle turns easily.
Fixation of the mill
Fasten the mill on a work surface,
Sense of rotation
Turn the handle to the left ( this corresponds to the clockwise
rotation in vertical position) In the horizontal position the muscle
power is optimally used by turning it to the left.
Setting the fineness
The adjustment knob is situated under the housing.
Turn it by holding the handle.
-
Turn it to the left for a coarse grinding
-
Turn it to the right for a fine grinding
(please see the arrow on the knob)
To change the setting from coarse to the finest, it’s recommended to
turn the handle two times to the right, so you get an opening
between the mill stones.
Michael Gergen
Hüttenstraße 6
D-66839 Schmelz
Tel. +49 (0) 68 87-1557
Fax. +49 (0) 68 87 - 77 77 24
www.kornkraft.de
[email protected]
G
E T R E I D E M Ü H L E N
