Appendices
245
Option board/memory installation
procedure
Before you perform the installation, be sure to read the
foregoing section “Please note when installing an
option board/memory.”
1. Preparations for installation
During the installation, be careful not to cut your hand
on any sharp edges of the TRITON or of the option
board/memory.
1
You will need a “+” (plus) screwdriver.
2
Turn off the TRITON, and disconnect the AC/AC power
supply cable and any other cables by which other devices
are connected.
2. Detaching the lid
1
Remove the four screws by hand.
2
Pull the lid toward the back, and lift to remove it.
3–1. Installing the EXB-MOSS
You must leave the AC/AC power supply disconnected
until you finish the entire process of removing the lid,
installing the option board or memory, and reattaching
the lid.
1
Verify the location where the EXB-MOSS will be
installed. (
☞
the lower diagram in “2. Detaching the lid”)
2
Remove the EXB-MOSS from its bag.
3
Note that screws and washers are attached to the four
corners of the board.
EXB-DI connector
EXB-SCSI
connector
EXB-MOSS
connector
EXB-mLAN
connector
Screw holes for
installing the EXB-MOSS
Factory-installed DRAM SIMM
EXB-PCM
slots
DRAM SIMM
slots
Front panel
With the lid removed
Rear panel
Screw
Washer