Korg TONEWORKS AX3A, Owner'S Manual

Page: 6 / 36

6
position, and Edit mode when at the [PRE FX]–[DELAY/REV-PARAM]
positions.
2. Program/Value display
In Edit mode, this display indicates the effect type (F0–F9, LE, nr, nF),
the parameter (P1–P4) or its setting (value).
In Write mode or Program mode, the display indicates the program num-
ber. When BYPASS/MUTE is active, the display indicates the name of
the note you’re tuning.
3. [
▲
(WRITE)], [
▼
(CANCEL)] buttons
In Effect mode, use these buttons to switch effect types or parameters.
By pressing the two buttons simultaneously, you can turn each effect
on/off. In Write mode, use these buttons to write a program.
In Program mode, you can press these buttons to increment or decre-
ment the program number in steps of 10. When you’re using the tuner,
use these buttons to adjust the calibration setting.
4. Value knob
In Edit mode, use this knob to adjust the value of a parameter. In Write
mode, you can use this knob to specify the writing-destination for the
program. In Program mode, this knob acts as the master volume.
5. Program Up switch
In Program mode, use this to select programs. The program number will
increase each time you press the switch. In Edit mode, press this to
make the parameter value appear in the program/value display. In this
case, the LED above the pedal will light, indicating that the program/
value display is showing the value of the effect parameter.
6. Program Down switch
In Program mode, use this to select programs. The program number will
decrease each time you press the switch. In Edit mode, press this to
make the effect or parameter type appear in the program/value display.
In this case, the LED above the pedal will light, indicating that the pro-
gram/value display is showing the type of effect or parameter.
Rear panel
1 2 3 4
1. Input jack
Connect your guitar to this jack.
2. Output jack
Connect this jack to your guitar amp or headphones.
3. Pedal jack
You can connect an optional Korg EXP-2 foot controller or XVP-10 ex-
pression/volume pedal to this jack.
A pedal connected here will function as a wah pedal if you’re using WAH
in [PRE FX], or as a volume pedal otherwise.
4. Power supply
~DC9V
You can connect an optional AC adapter to this jack.
Setup
Installing batteries