KR-55 Pro Quick Start Guide
6
Setup
Connections
Before connecting anything, turn off the power or
minimize the volume to all devices. Careless operation
could damage your speaker system or cause unexpected
malfunctions.
1. Connect a mic to the MIC IN jack (XLR jack) of the
KR-55 Pro.
Condenser mics cannot be used.
2. Connect a guitar or bass guitar to the INPUT 1 and
INPUT 2 jacks of the KR-55 Pro.
3. Connect an external device such as a powered monitor
speaker to the OUTPUT L/MONO and R jacks of the
KR-55 Pro.
Connect your headphones to the
jack.
Inserting or removing an SD card
SD cards that can be used with the KR-55 Pro
The KR-55 Pro can use the following types of SD cards: SDHC
(UHS-I) 4 GB–32 GB recommendation.
1.
Make sure that the power is off.
2. Insert the SD card into the SD card slot located on the
rear panel of the KR-55 Pro until you hear the card click
into place.
3. To remove the SD card, push it inward until you hear it
click; then release your finger.
4. The SD card pops out slightly, allowing you to remove it.
Note:
For details on how to properly handle SD cards, refer to
the manual included with your SD card.
Guitar, bass, etc.
to
an AC outlet
AC adapter
Headphones
Powerd monitor speaker
VOX VFS5
SD card
MIC IN
INPUT 1/INPUT 2
Electronic musical
instrument, etc.
Mic
Formatting an SD card
Before an SD card can be used, it must be formatted on this
instrument.
You should also format the card in the following cases.
•
If the display shows the error message (“Err-Crd-***”) at
start-up.
•
If the display shows the error message when playing or
recording a song.
1.
Press the [SYSTEM] button to enter System mode (the
button lights).
2.
Press the [M8] button (the button blinks).
The display indicates
“Init” (Initialize), and the [Set/OK]
button blinks.
3.
To format the card, hold down the [Set/OK] button for
approximately one second.
During formatting, the display's “Init” indication and the
[SD Card] button will blink.
When formatting has ended successfully, the display
indicates “End”.
When you format an SD card, all data on the card is lost.
Testing whether recording can be done on an SD card
Note:
See “SD card test function “tESt”” on page 23
Turning the power on/off
The KR-55 Pro can use either an AC adapter or batteries.
Using the AC adapter
Use only the included AC adapter. You risk causing a
malfunction if you use any other AC adapter.
1.
Make sure that the power of the KR-55 Pro is off.
Check that nothing is shown in the display, and that the
buttons are unlit.
2. Connect the DC plug of the AC adapter to the DC 9V
jack located on the rear panel.
3. Connect the plug of the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for the
adapter.
Using batteries
Batteries are not included. You must purchase them
separately.
1.
Remove the battery cover from the rear panel.
2. Install six AA
batteries, either alkaline or nickel-metal
hydride, taking care that each battery is oriented in the
correct polarity as shown in the illustration.
