7
Display mode settings
Select one of the display patterns that shows whether your instrument is out of
tune. The factory setting is
Regular
mode.
1. Press the DISPLAY/BRIGHT button.
The current setting will blink for several seconds in the note name display.
2. While this setting is shown, press the DISPLAY/BRIGHT button to select a
display pattern.
Each time you press the DISPLAY/BRIGHT button you will cycle through the
following settings.
With all display modes, the tuning guide LEDs indicate whether the pitch is
high or low. When the tuning is correct, both
and
light up. If the pitch
is flat, the
lights up; and if the pitch is sharp, the
lights up.
1
: Regular
Tune your instrument until the LED at the center of the LED meter lights up
brightly.
The LEDs on the meter light up from center to left if the pitch is flat (low), and
the LEDs light up from center to right if the pitch is sharp (high).
2
: Strobe
Tune your instrument until the LEDs stop running. Since the strobe meter has
a higher precision, it allows you to tune with greater accuracy.
The LED lights move from right to left when the pitch is flat, and from left to
right when the pitch is sharp.
3
: Half-strobe
Tune your instrument until the LEDs stop running and only the center LED is lit.
The LEDs on the meter from the center towards the left will strobe if the pitch is
low, and the LEDs from center towards the right will strobe if the pitch is high.
The pitch is sharp.
In tune.
The pitch is flat.
The pitch is sharp.
In tune.
The pitch is flat.
The pitch is sharp.
In tune.
The pitch is flat.