Korg PB-X-PRO, Owner'S Manual

Page: 7 / 47

En-6
Meter display setting
You can specify the display pattern that’s shown on the meter’s display. You can choose one of four dis-
play patterns.
The default setting is “1: Regular meter”.
1 . Press the DISPLAY button.
The current setting is shown for several seconds on the display (lit → blinking).
2 . While this setting is shown, press the DISPLAY button to select the desired display pattern.
The setting will change each time you press the button.
1: Regular meter
Tune your instrument so that the center LED of the meter display is lit up.
The LED illumination will move from the center toward the right if the note is sharp, or from the
center toward the left if the note is flat.
2: Strobe meter
Tune your instrument so that the illumination stops flowing in the meter display. The illumination
will flow from left to right if the note is sharp, or from right to left if the note is flat.
3: Half-strobe meter
Tune your instrument so that the stream stops and only the center LED is lit up. The right side of
the meter display will strobe if the note is sharp, and the left side of the meter display will strobe if
the note is flat. When the pitch is correct, only the center LED will light up.
4. Focus meter
This mode enlarges the meter display within a ±10 cent range, for even more precise tuning.
Tune your instrument so that the center LED of the meter display is lit up.
When the tuning of the inputted note is within ±10 cents, the POWER ON LED changes to red
and the meter changes color. Also, the meter view enlarges to show the ±10 cent range.
The meter returns to the regular display when the tuning falls outside of the ±10 cent range.
3 . When you’ve chosen the desired setting, wait for two seconds without pressing any buttons.
The display indication will blink several times, and the meter display setting will be made. The
tuner will then return to its normal state, allowing you to tune.