Korg PA1X, User Manual, Page: 188 / 424

184
Sequencer operating mode
Song Edit: Transpose
Song Edit: Transpose
Here you can transpose the Song, a track or a part of a track.
After setting the various parameters, press Execute to start the
operation.
Track
Use this parameter to select a track.
All All tracks selected (apart for Drum tracks).
Track 1…16 Selected track.
Value
Transpose value (±127 semitones).
Start / End Tick
Use these parameters to set the starting and ending points of the
range to transpose.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at 1.01.000,
and the End at 5.01.000.
Bottom / Top Note
Use these parameters to set the bottom and top of the keyboard
range to transpose. If you select the same note as the Bottom and
Top parameters, you can select a single note, or a single percus-
sive instrument in a Drum track.
Song Edit: Velocity
Here you can change the Velocity value for the notes. An
Advanced mode is available, allowing you to select a velocity
curve for the selected range. This is useful to create fade-ins or
fade-outs.
After setting the various parameters, press Execute to start the
operation.
Track
Use this parameter to select a track.
All All tracks selected.
Track 1…16 Selected track.
Value
Velocity change value.
Start / End Tick
Use these parameters to set the starting and ending points of the
range to edit.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at 1.01.000,
and the End at 5.01.000.
Bottom / Top Note
Use these parameters to set the bottom and top of the keyboard
range to edit. If you select the same note as the Bottom and Top
parameters, you can select a single percussive instrument in a
Drum track.
Advanced
When this checkbox is checked, the “Intensity”, “Curve”, “Start
Velocity Value” and “End Velocity Value” parameters can be
edited.
Intensity
(Only available in Advanced mode). Use this parameter to specify
the degree to which the velocity data will be adjusted toward the
curve you specify in “Curve”.
0…100% Intensity value. With a setting of 0 [%], the veloc-
ity will not change. With a setting of 100 [%], the
velocity will be changed the most.
Curve
(Only available in Advanced mode). Use this parameter to select
one of the six curves, and to specify how the velocity will change
over time.
Start / End Vel. Value
(Only available in Advanced mode). Velocity change at the start-
ing and ending ticks of the selected range.
0…100 Velocity change in percentage.
Start
Value
Curve 1
Velocity
Start Value = 0%, End Value = 100%
127
1
End
Value Start
Value
Curve 2
Velocity
127
1
End
Value Start
Value
Curve 3
Velocity
127
1
End
Value
Start
Value
Curve 4
Velocity
127
1
End
Value Start
Value
Curve 5
Velocity
127
1
End
Value Start
Value
Curve 6
Velocity
RANDOM
127
1
End
Value