NEB-2 User Guide
1. Connect the audio signal as shown in the figure above.
2. Connect the 12V AC adapter or a stabilized DC power supply, and turn on the POWER SW. (Nutube glows blue)
3. Set the [Nutube - BYPASS] SW to the “Nutube” side.
4. Set the 4 Types Tone Select switch to 4 (the most harmonics)
5. Adjust the volume of the device connected to the input to an appropriate value.
(Set it to just below the level that gets distorted).
6. While switching the Nutube-BYPASS switch back and forth, adjust the Nutube VOLUME so that the volume is the same
in both positions.
7. Take advantage of the 4 Types Tone Select SW and enjoy the difference in tone due to harmonics.
1. 上記の図のように接続してください。
2. AC(12V)アダプターまたは外部電源を接続し、POWER SWをONしてください。
(Nutubeが青く光ります)
3. 出力側の[Nutube - BYPASS]SWをNutube側にしてください。
4. 倍音切り替えスイッチ(4 Types Tone Select SW)を4に設定してください。
(倍音が一番多い状態にします)
5. 入力の接続機器の音量を適正な値に調整してください。
(歪む直前の値に調整する事をお勧めします)
6. [BYPASS]と[Nutube]の音量が同じレベルになるように、[Nutube - BYPASS]SWの切り替えを繰り返して音量を比較しながら
Nutube VOLUMEを調整します。
7. 倍音切替えスイッチ[4 Types Tone Select SW]を4段階切り替えて、倍音による音色の違いをお楽しみください。
Set the 4 type Tone Selector switches to MODE 1.
Connect an oscilloscope or voltmeter to pin 7 of IC2 (left) or IC3 (right). Turn BIAS ADJ LEFT or RIGHT to adjust the
voltage to 6V.
4Types Tone Select SWをMODE1にします。
IC2(または3)の7番ピンにオシロスコープもしくはテスターを接続しBIAS ADJ LEFT(または RIGHT)を回して7番ピンの電圧を
6Vに調整します。
How to adjust the Nutube Bias
*
The bias is pre-adjusted to
+
5V
〜+
7V at the time of shipment.
Nutube Bias調整法
*出荷時にBIASは+5V〜+7Vに調整済みとなっています。
V+
GND
Stabilized
DC power supply
7~20V(Recommend12V)
AC Adapter
DC12V
MAX INPUT LEVEL +2dBu
Audio player
Powered monitor speaker
or audio system
Use one of them to supply power
2.1mm I.D. - 5.5mm O.D.
Introduction
はじめに
Connection Example
接続例
Summary of Contents for Nutube NEB-2
Page 3: ... ...