Korg NAUTILUS Series, Parameter Manual, Page: 851 / 961

Delay 087: Reverse Delay
841
BAND4 LFO
Band 4’s LFO has the same parameters as the “BAND1
LFO,” above.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
087: Reverse Delay
This is a delay that plays back the input signal in reverse.
You can also continue feedback while alternating playing the
signal in reverse and forward directions.
INPUT
Input Level Dmod [%] [+/–100]
Sets the modulation amount of the input level.
Source [Off…Tempo]
Selects the modulation source for the input level.
REVERSE DELAY
Reverse Time [msec] [0…900]
Sets the length of the reverse playback (the delay time). For
more information, see “Reverse Time and Sync Source,”
below.
Level [0…100]
Sets the output level of the reverse playback.
L Post-Delay Time [msec] [0…900]
Sets the delay time of the Left Tap.
Level [0…100]
Sets the output level of the Left Tap.
R Post-Delay Time [msec] [0…900]
Sets the delay time of the Right Tap.
Level [0…100]
Sets the output level of the Right Tap.
Feedback Mode [Reverse, Reverse/Forward]
Reverse : the feedback plays in reverse.
Reverse/Forward : the feedback alternates between playing
backwards and forwards, as shown below.
Feedback [+/–100]
Sets the feedback amount.
Source [Off…Tempo]
Selects the modulation source of feedback amount.
Amount [+/–100]
Sets the feedback amount.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation for the
feedback path.
Sync Source [Off…Tempo]
Selects a modulation source to reset the start point of the
reverse delay. For more information, see “Reverse Time and
Sync Source,” below.
Reverse Time and Sync Source
The sound will be played in reverse for the duration
specified by
Reverse Time . You can reset the dividing point
for reverse playback by specifying a modulation source for
Sync Source .
If you set Sync Source to Gate1, the delay will be reset at
each note-on. This means that you will always hear the
reverse playback of the sound that occurs between the note-
on and the specified
Reverse Time .
If you don’t specify a Sync Source , the location at which
reverse playback starts will be indeterminate.
+
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
D -mod
Trigger
Reverse
High Damp Trim
Level
Feedback
Feedback
Feedback Mode
Delay
Sync
Feedback Mode
Input
wet
wet
Feedback Mode: Revese
Time
Feedback Mode: Revese/Forward
Reverse Time/Sync
Input
wet
Time
Reverse Time
Sync
reset
Reverse Time