Korg NAUTILUS Series, Parameter Manual, Page: 611 / 961

SAMPLING > MFX/TFX 9–1: Routing
601
SAMPLING > MFX/TFX
Here you can select the effect types for the master effects
and total effects, and turn them on/off.
The master effects are output to the L/R bus. The total
effects are inserted in the L/R bus. If you want to use these
while sampling, set
Source Bus to L/R.
For more information, please see the “Effect Guide,”
beginning on page 729.
Note: When you sample, MFX1 On/Off , MFX2 On/Off ,
TFX1 On/Off , and TFX2 On/Off are automatically turned
off. This is done so that the effect will not be applied again
(i.e., a second time) when you play back the sample that was
resampled with the MFX1/2 and TFX1/2. (In the same way,
the
Bus Select (All OSCs to) parameter will automatically
be set to L/R.) Be aware of this if you want to sample again.
9–1: Routing
9–1a: MFX
The master effect does not output the direct sound (Dry).
Adjust the
Return 1 and Return 2 levels to return the signal
to the L/R bus and mix it with the L/R bus signal.
The master effects are stereo-in/out, but depending on the
selected effect type, the output may be monaural. See
“In/Out” on page 737.
The meters below the effects names display the effect output
levels in realtime, showing the combined peak signals of the
left and right channels.
MFX1
MFX1 [000…197]
This selects the effect type for master effect 1. Choose from
000:No Effect – 197: Rotary Speaker Pro CX Custom. If you
choose 000:No Effect, the output from the master effect is
muted.
Category/MFX Select menu
When you press the popup button, the Category/MFX Select
menu will appear, letting you select effects by category. Use
the tabs to select a category, and then select an effect within
that category. Press the OK button to execute your selection,
or press the Cancel button to cancel.
MFX1 On/Off [Off, On]
Switches the master effects 1 on/off. When off, the output
will be muted. This will alternate between on and off each
time it is pressed.
Separately from the settings here, you can use control
change #94 to turn master effects 1 and 2 off. A value of 0
turns them off, and values of 1–127 restore the original
setting. The global MIDI channel specified by
MIDI
Channel (GLOBAL 1–1a) is used for this message.
Return 1 [000…127]
This specifies the return level from the master effect to the
L/R bus (after which it passes through TFX1 and 2, and is
sent from L/MONO and R).
MFX2
MFX2 [000…197]
MFX2 On/Off [Off, On]
Return 2 [000…127]
These parameters specify the effect type for master effect 2,
its on/off status, and the return level from master effect 2 to
the L/R bus. See “MFX1” on page 601.
9–1PMC
9–1a
9–1b