Korg NAUTILUS Series, Parameter Manual, Page: 564 / 961

SEQUENCER mode
554
Note: The slot’s MIDI control channel, as specified by the
Ch parameter on the IFX1–12 pages, will not be copied.
Swap Insert Effect
Please see “Swap Insert Effect” on page 122.
Note: The slot’s MIDI control channel, as specified by the
Ch parameter on the IFX1–12 pages, will not be swapped.
Insert IFX Slot
Please see “Insert IFX Slot” on page 122.
Cut IFX Slot
Please see “Cut IFX Slot” on page 123.
Clean Up IFX Routings
Please see “Clean Up IFX Routings” on page 124.
DrumKit IFX Patch
Please see “Drum Kit IFX Patch” on page 437.
Copy MFX/TFX
Please see “Copy MFX/TFX” on page 125.
Note: The slot’s MIDI control channel, as specified by the
Ch parameter on the MFX1–2 pages, will not be copied.
Swap MFX/TFX
Please see “Swap MFX/TFX” on page 125.
Note: The slot’s MIDI control channel, as specified by the
Ch parameter on the MFX1–2 pages, will not be swapped.
Write FX Preset
Please see “Write FX Preset” on page 125.
Put Effect Setting to Track
This inserts effect settings into a track as System Exclusive
events. Use this when you want to change the effect settings
during a song.
If you use MIDI parameter change system exclusive
messages to change the effect settings, it will take a
certain amount of time for the effect change to occur. In
addition, the sound may not change smoothly if sound is
being produced at that time. Be aware of the timing of
your playback data, and make the appropriate
adjustments to the location at which the system exclusive
message is inserted.
Note: If you switch effects during the song, you should
also insert this command at the beginning of the track
(
Measure 001, Beat.Tick 01.000) as well, so that the
song starts with the correct effect.
1. Use IFX page, or MFX/TFX page to edit the effect you
want to insert (IFX1–12, MFX1, 2, TFX 1, 2), and
determine the song, track, measure, beat, and clock at
which you should insert the System Exclusive event.
For example, let’s suppose that IFX6 which is used on
track 3 needs to change at the beginning of measure 9.
2. Select Put Effect Setting to Track to open the dialog
box. (The values shown in the dialog box are the
settings for example (1).)
3. Use Effect to select the effect that you want to insert.
4. Use To: Song to specify the song, Track to specify the
track, Measure to specify the measure, and Beat.Tick
to specify the beat and clock at which you want to
insert the event.
5. Press the OK button to execute the Put Effect Setting
to Track command. If you decide to cancel, press the
Cancel button.
The inserted event contains only the type of effect and the
effect parameters. You’ll need to realtime-record the
effect on/off status and the bus, etc.