Korg NAUTILUS Series, Parameter Manual, Page: 134 / 961

PROGRAM mode: HD-1
124
Drum Kits not supported by Auto Routing
Drum Kits can store separate Bus Select settings for each
key. Because these settings are stored in the Drum Kit, and
not the Program, the
Auto Routing option can’t correct
them.
Drum Kit Programs will use these separate Bus Select
settings if the IFX Routing page’s Use DKit Setting
parameter is turned On .
In this case, you have two options. Either:
• Use Auto Routing , and then manually adjust the Bus
Select settings for each key of the Drum Kit to match the
new IFX slot arrangement.
or:
• Don’t use the Cut IFX Slot command. Instead, remove
the unwanted IFX slot by changing the Chain to
settings, or by using the Copy IFX or Swap IFX
commands.
Clean Up IFX Routings
Clean Up IFX Routings is available on the Insert FX and
Track View tabs of the IFX page.
This command automatically rearranges unused IFX slots so
that they are consecutive. It also rearranges effects in a
discontinuous chain so that they are consecutive. Related
parameters are automatically adjusted in order to preserve
the existing routings.
If editing an IFX chain results in unused slots, or if the
connections in a chain have become disorganized, you can
execute this command to clean up the routing.
1. Access the Insert FX page.
In this example, IFX1 → IFX5 → IFX11 → IFX12 are
chained, and the remaining slots are all vacant.
2. Select “Clean Up IFX Routings” to open the dialog
box.
3. Press the OK button to execute the Clean Up IFX
Routings command, or press the Cancel button if you
decide to cancel.
In this example, the discontinuous chain
IFX1
→
IFX5
→
IFX11
→
IFX12 has been reorganized into
IFX1
→
IFX2
→
IFX3
→
IFX4, and the vacant slots (000:
No Effect, unless located within a chain) have been
rearranged consecutively.
At this time, the following parameters are automatically
adjusted to maintain the existing routings.
• Routing: Bus Select
• Routing- Page Menu: DKit Patch (Combi/Seq)
If the program uses a drum kit, and the Routing page
“Use DKit Setting” is on, you may have to change the
Bus Select setting for each key of the drum kit in order to
reproduce the previous routing status.
In such cases, don’t use the “Clean Up IFX Routings”
command. Instead, rearrange the IFX slots by making the
appropriate
Chain to settings or by using the “Copy
Insert Effect” or “Swap Insert Effect” commands.