Korg NAUTILUS Series, Parameter Manual, Page: 437 / 961

COMBINATION > IFX 8–7: IFX 1–12
427
8–7: IFX 1–12
This page lets you edit the parameters of the insert effect 1.
Use the tabs at left to select IFX1 through IFX12.
Effects Modulation: Dmod
Most effects have one or more parameters which can be
modulated in realtime. In the NAUTILUS, this is called
Dynamic Modulation, or Dmod for short.
For a complete list of Dmod sources, see “Dynamic
Modulation Source List” on page 910.
You can use different MIDI channels to control Dmod for
each effect, if desired, as selected by the
Ch (Control
Channel) parameter.
8–7a: IFX1
IFX Type
This selects the effect type for insert effect 1.
IFX1 On/Off [Off, On]
Turns the insert effect on/off. This is linked with the on/off
setting in the IFX– Insert FX page.
Ch (Control Channel) [Ch01…16, G ch, All Routed]
This parameter specifies the MIDI channel that will be used
to control effect dynamic modulation (Dmod), pan following
the insert effect (CC#8), Send 1, and Send 2.
The channel number of the timbre routed through this IFX
will be followed by a “*” displayed at the right of Ch01–16.
If two or timbres with different MIDI channel settings are
routed through the same IFX, this parameter specifies which
of these channels will be used to control the effect.
G ch: The global MIDI Channel (GLOBAL 1–1a) will be
used to control the effect. Normally you will set this to G ch.
All Routed: The channel of any timbre routed through this
effect can be used to control the effect. (Channels of each
routed timbre will be indicated by “*”.)
Drum Kits and the MIDI Control Channel
If a Timbre is using a Drum Kit, and the Timbre’s Bus Select
(IFX/Indiv. Out Assign) DKit (8–1b) is enabled, this
effects the MIDI Control Channel as well. In this case, the
Timbre’s MIDI channel will be used to control any effect
whose
Ch is set to All Routed, regardless of the Bus Select
(GLOBAL 5–3b) settings or the settings of the DrumKit
IFX Patch page menu command.
P (Effect Preset) [P00, P01…15, U00…15, --------]
This selects the effect preset.
For more information, please see “Effect preset function” on
page 103.
IFX1 Parameters
Set the parameters for the effect type selected for insert
effect 1.
For more information, please see “Insert Effects
(IFX1…IFX12)” on page 737.
8–7b: IFX2…12
This configures the parameters of insert effects 2–12.
The parameters for IFX2 through IFX12 are the same as for
IFX1. For more information, please see “8–7a: IFX1” on
page 427.
8–7PMC
8–7a
8–7b