Korg NAUTILUS Series, Parameter Manual, Page: 118 / 961

PROGRAM mode: HD-1
108
Chain Direction [MFX1->MFX2, MFX2->MFX1]
Specifies the direction of the connection when MFX1 and
MFX2 are chained.
MFX1
→
MFX2: Connect from MFX1 to MFX2.
MFX2
→
MFX1: Connect from MFX2 to MFX1.
Chain Level [000…127]
When chain is On, this sets the level at which the sound is
sent from the first master effect to the next master effect.
9–1b: TFX1, 2
These are the parameters for total effect 1 and 2, which are
placed at the final stage of the L/R bus. After passing
through the total effects, the sound is output to AUDIO
OUTPUT (MAIN OUT) L/MONO and R.
For the total effects, the direct sound (Dry) is always stereo-
in/out. The input/output configuration of the effect sound
(Wet) will depend on the selected effect type.
The total effects are stereo-in and stereo-out, but the output
may be monaural depending on the type of effect you select.
(See “In/Out” on page 737.)
TFX1
TFX1 [000…197]
This selects the effect type for total effect 1. You can use any
of the available effects, without limitation.
Category/TFX Select menu
When you press the popup button, the Category/TFX Select
menu will appear, letting you choose effect types by
category. Use the tabs to select an effect category, and then
choose an effect within that category. Press the OK button to
execute your choice, or press the Cancel button to cancel.
You can also use the Find button to search for effects by
name. For more information, see “Find dialog” on page 7.
TFX1 On/Off [Off, On]
This turns total effect 1 on/off. If this is off, the input will be
passed directly through. The setting will alternate between
on/off each time you press this.
Separately from this setting, you can use control change
#95 to turn both total effects off. A value of 0 turns them
off, and values of 1–127 restore the original setting. The
global MIDI channel specified by
MIDI Channel
(GLOBAL 1–1a) is used for this message.
TFX2
TFX2 [000…197]
TFX2 On/Off [Off, On]
These parameters specify the effect type and on/off status for
total effect 2. See “TFX1” on page 108.
9–1c: Master Volume
Master Volume [000…127]
This controls the final volume level after total effects 1 and
2, as heard at AUDIO OUTPUT (MAIN OUT) L/MONO
and R.
The stereo meter to the right of the volume control shows the
audio levels at the main output in realtime, including
clipping.
v 9–1: Page Menu Commands
• Compare → p.112
• Write Program → p.112
• Exclusive Solo → p.113
• Copy MFX/TFX → p.125
• Swap MFX/TFX → p.125
• PAGE → p.126
• MODE → p.126
Category/MFX Select menu