10
The nanoPAD2’s global parameters
Touch Scale
If the Touch Scale mode is “on,” moving your finger in the X-axis direction of the X-Y
pad will transmit note messages, and moving it in the Y-axis direction will transmit
control change messages.
CC
Note message
X-Y pad
MIDI Channel [1...16/Global]
This specifies the MIDI channel of the MIDI messages that are transmitted in the
Touch Scale mode.
If you choose “Global,” messages will be transmitted on the
Note On Velocity [1…127]
This specifies the Velocity of the Note messages that are transmitted in the Touch
Scale mode.
Y-axis CC Enable [Disable/Enable]
This enables/disables the Y-axis of the X-Y pad.
Y-axis Control Change Number [0…127]
This specifies the control change number of the transmitted control change messages.
Y-axis Polarity [Normal/Reverse]
This specifies the polarity of the Y-axis values of the X-Y pad.
Normal
Operation will be normal. The lower edge produces low values,
and the upper edge produces high values.
Reverse
High and low values will be inverted. The lower edge produces
high values, and the upper edge produces low values.
Gate Speed [1/48...1/2]
This specifies the resolution (the interval between notes) relative to the tempo speci-
fied for the Gate Arpeggiator when Touch Scale is “on.”
Notes will be played at the following resolution relative to the specified tempo.
1/48
3
1/32
1/16
1/12
3
1/8
1/6
3
3/16
1/4
1/3
3
3/8
1/2
Summary of Contents for nanoPad2
Page 1: ......