Global: Menu Command Write Global Setting
251
Global: Menu Command
Tip:
In each page, you can access (or switch on/off) up to the
first ten menu commands by holding down the ENTER
switch and pressing the corresponding numeric key, 0–9.
Tip:
While this command is open, the ENTER switch will
operate as the OK button and the EXIT switch will operate
as the Cancel button.
Procedure for menu commands
1. Select the menu command.
2. Make settings in the dialog box.
For details on the content of each dialog box, refer to the
following explanations of each command.
3. To execute, press the OK button. To cancel without exe-
cuting, press the Cancel button.
Write Global Setting
This command writes Global mode settings (except for
Drum Kits and Arpeggio Patterns).
You can also use the SEQUENCER REC/WRITE switch to
write data in the same way as the
Write Global Setting
command.
Press the SEQUENCER REC/WRITE switch to access the
Update Global Setting
dialog box, and press the OK button
to write the data.
Note:
To save the drum kit, execute the P5 menu command.
Note:
To save the arpeggio pattern, execute the P6 menu
command. (“Write Arpeggio Patterns”)
The Effect Global SW setting will not be saved.
Load Preload/Demo Data
This command loads the preloaded data and demo song
data into the M50.
Before you can load this data, you must navigate to
Memory Protect
(Global 0–1b) and un-check the protect
setting for the type of data you want to load. If you
execute this operation with the protect setting checked,
the display will indicate “Memory Protected,” and the
data will not be loaded.
1. Use Kind to select the type of data you want to load.
2. If you selected Program, Combination, Drum Kit, or
Arpeggio Pattern as the Kind, specify the range of data
that you want to load.
All:
load all data
Bank:
load an individual bank
Single:
load one item of data
3. If you’re loading Bank or Single, use To to specify the
loading-destination.
Change all bank references
This command changes all program banks specified for
timbres in combinations or tracks of songs.
1. If you wish to change bank references for combina-
tions, check Combination.
If you wish to change bank references for songs, check
Song
.
2. In Program Bank, specify the replacement for each
bank.
If you change two or more different banks to the same
bank, it will not be possible to use this function to
change them back to different banks. Be careful that the
change destination banks do not overlap.
Kind
Content
All (Preload PCG and
Demo Songs)
All PCG (Program, Combination, Global
settings, drum kit, , arpeggio pattern), and
demo song data
All Preload PCG
All PCG data
All Demo Songs
All demo song data
Program
Program data
Combination
Combination data
Drum Kit
Drum kit data
Arpeggio Pattern
Arpeggio pattern data
Global Setting
Global setting data
Summary of Contents for M50-73
