Korg M3, Parameter Manual

Page: 228 / 647

Sequencer mode
218
Note: For an interesting variation on this effect, turn Equal
Amount
Off, and instead set all of the Track Center
Volumes to 50%. The Tracks will still fade together
smoothly, but with a more gentle effect towards the
extremes of the X–Y axes.
1–2(3)b: X–Y Graphic
X–Y Graphic
The X–Y graphic is shown if Equal Amount is on, or to
indicate the way in which volume is changed by the Center
Volume setting.
Track Select [01…16]
This selects the track whose data will be shown in the X–Y
graph.
1–2(3)c: Track Info
Selected Track Info:
This area displays information about the track selected for
editing – T: track number/program bank/number/name,
Ch:
MIDI channel number.
Track Number:
This indicates the track number. The various parameters
below each track number make settings for the
corresponding track.
Track Category:
This shows the abbreviated category name of the Program
assigned to the track.
1–2(3)d: X–Y Assign, Center Volume,
Enable Program X–Y Volume
Track 1
X–Y Assign [Off, +X, –X, +Y, –Y]
This assigns an axis of the X–Y to control the Track’s volume.
See the diagram “X–Y Assign and Program Volume,” below,
for more details.
Off means that the X–Y position will not affect the Track’s
volume.
X–Y Assign and Program Volume
Center Volume [0, 25, 50, 75, 100%]
This sets the volume of Track 1 at the center point. It applies
only when Equal Amount, above, is set to Off.
The volumes at the extreme ends of the axis are fixed,
depending on the setting of the X–Y Assign parameter.
For instance, if X–Y Assign is set to –X, the Track will always
be at 100% volume on the left side, and 0% (silent) on the
right side.
This parameter applies only to the Song X–Y Volume
control, and does not change the Program’s individual X–Y
Volume settings.
Track Center Volume, X–Y Assign = –X
Enable Program X–Y Volume [Off, On]
When this is turned On, the Program’s X–Y Volume control
will function as it does in Program mode, crossfading
between Oscillators 1 and 2. The program’s X–Y volume
setting is controlled by the X–Y position.
When this is turned Off, the Program’s X–Y Volume control
will be disabled.
Select Track Info
Track Number
Track Category
+127 –127 0
0% 100%
+127 –127 0
100% 0%
+127
–127
0
0%
100%
+127
–127
0
100%
0%
+X –X
Program volume increases
from left to right. Program volume increases
from right to left.
+Y –Y
Program volume increases
from bottom to top. Program volume increases
from top to bottom.
50%
100%
0%
–127 0 +127
100
75
50
25
0
Volume
Vector X-axis position
Center Volume Values: