Korg M3, Parameter Manual

Page: 155 / 647

COMBI P1: DT/XY/Ctrls 1–7: Pad 1–4 Setup, 1–8: Pad 5–8 Setup
145
1–6c: Realtime Modulation Slider Assign
Here you can assign the functions (mainly types of control
change) that sliders 5–8 will have when Control Assign
REALTIME CONTROL is selected. (See “Realtime Control
Slider 5–8 Assignments” on page 598)
The functions you assign here are active when you select
CONTROL ASSIGN REALTIME CONTROL and operate
sliders 5–8.
Slider 5 [Off, ..., MIDI CC#119]
Slider 6 [Off, ..., MIDI CC#119]
Slider 7 [Off, ..., MIDI CC#119]
Slider 8 [Off, ..., MIDI CC#119]
▼
1–6: Menu Command
• 0: Write Combination
☞
p.185
• 1: Panel–SW Solo Mode On
☞
p.106
• 2: Exclusive Solo
☞
p.107
• 3: Copy from Program
☞
p.185
For more information, please see “Combination: Menu
Command” on page 185.
1–7: Pad 1–4 Setup,
1–8: Pad 5–8 Setup
There are eight velocity-sensitive trigger pads below the
display. These look like drum machine pads, and playing
drum sounds is certainly one use for them.
However, they can also play up to eight-note chords on any
sound–not just drums. The pads even remember the
velocities of the individual notes within the chord, as well as
the notes themselves.
These settings are stored independently for each
Combination.
Assigning notes to the pads
You can assign notes to the pads directly from the keyboard
and front-panel controls, without using this page at all.
Alternatively, you can enter notes and velocities using the
parameters on this page. Regardless of how the notes were
first assigned, you can edit their values here.
For more information, including step-by-step instructions
and usage tips, please see “Drum & Chord Pads” on page 44
of the Operation Guide.
1–7(8)a: Pads Chord
Pad 1:
MIDI Channel [Ch01...Ch16, Gch]
This sets the pad’s MIDI output channel. You can set this to
either a specific channel (1–16), or the Global MIDI Channel.
Ch01…Ch16: The pad will transmit on the selected MIDI
channel. As shown in the diagram “Pads and MIDI
Channel,” below, you can:
• Use this in conjunction with the Timbre MIDI Channel
(Combi 3–1(1)c) setting, to route a pad to a specific
Timbre. For more information, please see “MIDI
Channel” on page 149.
• Use this with the KARMA Module In (Input Channel)
(Combi 7–1–1c) setting, to generate a phrase or other
KARMA function when you play a specific pad. For
more information, please see “In (Input Channel)” on
page 162.
Gch: Use the global MIDI Channel setting. This is the
default. For more information, please see “MIDI Channel
(Global MIDI Channel)” on page 363.
1–7a
1–7
Menu