Korg M3, Parameter Manual

Page: 125 / 647

Program: Menu Command Copy Scene
115
Initialize KARMA Module
Initialize KARMA Module is available on all of the
KARMA pages, as well as the KARMA GE tab or KARMA
RTC of the Play page.
This command sets the KARMA Module’s parameters to
their default values.
The GE selection will not be initialized. The GE
parameter “Values” will be set to the default values that
are preset for the selected GE.
1. Select “Initialize KARMA Module” to open the dialog
box.
2. As appropriate for the settings you want to initialize,
you can turn on (check) the GE RTP Control settings &
Scenes and/or Perf. RTP & Panel Setting options.
For more information, please see “Settings initialized by
Initialize KARMA Module,” below.
3. To initialize the settings, press the OK button. To cancel
without initializing, press the Cancel button.
Settings initialized by Initialize KARMA Module
When initializing from a program
If you initialize with the GE RTP Control & Scenes and
Perf. RTP
options turned Off (unchecked), the following
parameters will be initialized.
• Settings of the KARMA module parameters (7–1:
KARMA1– Trigger page, 7–1: KARMA1– Control page).
• 7–2: KARMA2– GE RTP MIN, MAX, and VALUE (they
will return to the values preset by the GE).
The GE selection will not be initialized.
If you initialize with “GE RTP Control & Scenes” turned
On (checked)
In addition to the parameters initialized with the Off
(unchecked) setting, the following parameters will also be
initialized.
• 7–2: KARMA2– GE RTP ASSIGN (
→
Off) and POL.
(
→
+).
• KARMA Sliders 1–8 and KARMA Switches 1–8 settings
in each scene (
→
064/0).
• KARMA Sliders 1–8 and KARMA Switches 1–8 names
(
→
no name).
If you initialize with “Perf. RTP” turned On (checked)
In addition to the parameters initialized with the Off
(unchecked) setting, the following parameters will also be
initialized.
• 7–1: KARMA1– Drum Track Control page settings.
• 7–2: KARMA2– Perf RTP page settings.
• 7–2: KARMA2– Dynamic MIDI page settings.
Copy Scene
Copy Scene is available on all of the KARMA pages, as well
as the KARMA GE tab or KARMA RTC of the Play page. It’s
also available on the Control Surface page, when
CONTROL ASSIGN
is set to KARMA.
This command copies settings for the KARMA Scenes. You
can use this command when you want to make settings for a
scene based on the other scene settings you edited, or vice
versa.
1. Select “Copy Scene” to open the dialog box.
2. In From select the scene that you wish copy.
3. In To select the copy destination scene.
4. To execute the copy, press the OK button. To cancel
without executing, press the Cancel button.
Swap Scene
Swap Scene is available on all of the KARMA pages, as well
as the KARMA GE tab or KARMA RTC of the Play page. It’s
also available on the Control Surface page, when
CONTROL ASSIGN
is set to KARMA.
This command swaps (exchanges) the settings of two
KARMA Scenes.
1. Select “Swap Scene” to open the dialog box.
2. In Source1 and Source2, select two KARMA Scenes.
that you wish to swap.
3. To execute the Swap KARMA Scene command, press
the OK button. To cancel, press the Cancel button. You
can then continue by specifying Source 1 and Source 2
and executing again.