6
Let’s try sampling
1
Connect the audio device from which you want to sample to the
ESX-1’s audio input jack (AUDIO IN).
2
Turn the AUDIO IN THRU key on (the key will light), and check
the input sound.
3
Adjust the output level of the external device or the AUDIO IN
LEVEL knob of the ESX-1 so that the peak icon (CLIP) does not
light even when the output of the connected device is loudest.
4
Press the SAMPLE key (the key will light).
Press the [ ] cursor key to make the display read “(sample name)”
(the SAMPLE icon will light).
5
Hold down the SHIFT key and press the REC key to enter sam-
pling-ready mode (the REC key and PLAY/PAUSE key will both
blink).
If you decide to cancel the procedure before you actually begin
sampling, you can press the STOP/CANCEL key at this point.
6
Specify the sampling mode (the display indicates “SmplRec”).
Turn the dial to set the sampling mode to either “Stereo”(stereo)
or “Mono” (monaural) sampling.
7
Press the PLAY/PAUSE key to start sampling at the desired mo-
ment (the REC key will blink, and the PLAY/PAUSE key will light).
8
Sampling will end when you press the STOP/CANCEL key (the
REC key and PLAY/PAUSE keys will go dark).
You can press the PLAY/PAUSE key to hear the sample that you
just recorded.
This jack is a stereo phone plug. You can also con-
nect a monaural phone plug. Before you continue, set
the Global mode AUDIO IN MODE setting to either
monaural or stereo as appropriate (
☞
Owner’s manual
p.83).
3
2
4
5
1
7
5
8