Hardware Installation
Korenix JetNet 3500 Series Industrial Unmanaged Redundant Ethernet Rail Switch User’s
Manual
2-7
Follow the steps below to mount the JetNet to the DIN-Rail track.
1. First, insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its
upper side.
2. Lightly push the bottom of the DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is tightly attached on the track.
4. To remove the JetNet from the track, reverse the steps above.
Wall-Mounting Installation
Follow the steps below to install the JetNet with the wall mounting plate.
1. To remove the DIN-Rail clip from the JetNet, loosen the screws from the DIN-Rail clip.
2. Place the wall mounting plate on the rear panel of the JetNet.
3. Use the screws to tighten the wall mounting plate onto the JetNet.
4. Use the hook holes at the corners of the wall mounting plate to hang the JetNet onto the wall.
5. To remove the wall mounting plate, reverse the steps above.
