11
4. System Installation
4-1. Installation and Testing
1. Take out your JetNet 3212G-2C2F Industrial Gigabit Ethernet switch from the
package box.
2. Check if the DIN-Rail clips attached to the JetNet 3212G-2C2F product . If the
DIN-Rail clip is not attached to the product , refer to
DIN-Rail Mounting
section for DIN-Rail installation.
3. To place the JetNet 3212G-2C2F product on the DIN-Rail track or wall, refer to
the
Mounting Installation
section.
4. Pull the terminal blocks off the JetNet 3212G-2C2F product and wire the power
lines. Refer to 2-4 the
Wiring the DC Power Inputs
section for how to wire the
power inputs.
5. PWR1 and PWR2 dual power inputs can be connected to power sources
simultaneously. When the primary power source fails (the default setting is
PWR1), the system will automatically switch to the secondary power source
(PWR2), preventing any power interruption.
Both of Power 1 and Power 2 support positive electricity power system.
6. Check the LEDs of PWR1 and PWR2 to make sure that JetNet 3212G-2C2F
series product is operating normally.
7. Use Category 5e or Category 6 straight through Ethernet cables with RJ-45
connectors to connect network devices.
8. Connect one side of an Ethernet cable with a RJ-45 connector to the JetNet
3212G-2C2F pro
duct’s Ethernet port (RJ-45 port), and the other side of the
Ethernet cable to the network device
’s Gigabit Ethernet port.
9. If you want to connect with Gigabit Fiber, please install appropriate SFP fiber
transceiver and fiber cable. To ensure the connection is working, please notice
