5
JetI/O 6510 Appearance:
LED Indicators:
System LED
PWR
Power Input plugged and On (Green)
RDY
System startup ready (Red)
Ethernet LED
Upper (LAN Activity)
Orange On & Blinking
Lower(10M/100M)
10M (Green Off) /100M(Green ON
2.2 Wiring Power Input
Follow below steps to wire JetI/O DC power inputs.
1.
Follow the pin assignment to insert the wires into the contacts on the terminal block
connector.
2.
Tighten the wire-clamp screws to prevent DC wires from being loosened.
3.
Connect to and turn on the power source. The suitable working voltage is 24VDC.
4.
When the unit is ready, the PWR LED turns Greed, the RDY LED turns Red.
Note1:
It is a good practice to turn off input and load power, and to unplug power terminal
block before making wire connections. Otherwise, your screwdriver blade can
inadvertently short your terminal connections to the grounded enclosure.
Note 2:
The range of the suitable electric wire is from 12 to 24 AWG.
