Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1139/1246
9.6.3
Managing OSPF
9.6.3.1
Configuring OSPF
Configurable Data
Router ID
- The 32 bit integer in dotted decimal format that uniquely identifies the router within the
autonomous system (AS). If you want to change the Router ID you must first disable OSPF. After
you set the new Router ID, you must re-enable OSPF to have the change take effect. The default
value is 0.0.0.0, although this is not a valid Router ID.
OSPF Admin Mode*
- Select enable or disable from the pull-down menu. If you select enable OSPF
will be activated for the switch. The default value is disable. You must configure a Router ID before
OSPF can become operational. You do this on the IP Configuration page or by issuing the CLI
command: config router id.
!
Once OSPF is initialized on the router, it will remain initialized until the router is reset.
RFC 1583 Compatibility
- Select enable or disable from the pull-down menu to specify the
