2
EDITION NO. : KA2M20207102R2
1. Safety instructions before completing installation
Air chain hoists are only intended for lifting and moving loads and may be used as stationary or
traveling units. Air chain hoists may only be operated when in perfect working order by trained
personnel in accordance with the relevant safety and accident prevention regulations. This also
includes compliance with operating and maintenance conditions specified in the operating
instructions. Any failure to comply with the safety instructions stated in these operating instructions
can result in death or personal injury. Observe general statutory and other bligatory regulations
relating to accident prevention and environmental protection and basic health and safety
requirements in addition to those included in these operating instructions. Such requirements my
relate, for example, to the handling of hazardous materials or the provision/wearing of personal
protection equipment. We assume no liability for damage and malfunctions resulting from failure to
comply with the operating instructions.
1.1 General safety instructions
- All instructions and measures described in the operating instructions with regard to safe
operation and items concerning general safety and accident prevention which have to
be observed before, during and after putting into service must be strictly complied with.
- Never use the air hoist for lifting or lowering people, and never allow anyone to stand
on a suspended load.
- Safe operating instructions are provided to make all operators aware of dangerous
practices to avoid and are not necessarily limited to the following list.
- Comply with these regulations and general accident prevention regulations relevant for
the place at which the air chain hoist is used and follow the instructions therein when
working with the air chain hoist.
1.2 Air supply and lubrication
- The required operating air pressure is 620kPa(6.2kg/㎠) for the satisfactory efficiency
at the specified maximum lift speed. If necessary, the regulator should be installed.
- Air filter and Lubricator should be provided at the nearest location of air inlet.
- Under normal operation conditions, the oil must be checked periodically. Under
exceptional conditions, e.g. increased ambient temperatures, we recommend that oil
changes be adapted to suit these conditions.
- The quantity of flushing oil used should be checked periodically.
- The distances between FRL and air hoist should be kept within 5m.
1.3 Safety instructions for operators
- Do not exceed the maximum permitted load and permitted load dimensions.
- Do not leave suspended loads unsupervised.
- Do not allow the chain to run over edges.
2. Specifications
Model
Rated Load
(kg)
Air Pressure
(kg
f
/cm
2
)
Lifting speed
(m/min)
Air Consumption
(kg
f
/cm
2
)
Air Inlet
(inch)
Mass(kg)
*per Chain 1m
1kg add
KA2S-100PB
1,000
6
6.5
1.8
1/2
81
KA2S-200PB
2,000
6
3.2
1.8
1/2
86
Summary of Contents for KA2M Series
Page 20: ...19 EDITION NO KA2M20207102R2 8 Air Circuit Diagram for Air Hoist 8 1 Normal Type Standard ...
Page 21: ...20 EDITION NO KA2M20207102R2 8 2 Pull Type Controller Option ...
Page 22: ...21 EDITION NO KA2M20207102R2 8 3 Safety Valve Type Option ...
Page 23: ...22 EDITION NO KA2M20207102R2 8 4 Overload Protector Type Option ...