11
Kordis Media Co.,ltd
Data Sheet NCB210X1
CONNECTION & OPERATION
CAUTION
:
Never connect or disconnect parts of the display system when the system is powered up as
this may cause serious damage.
CONNECTION
1.
LCD panel & Inverter:
Connect the inverter (if it is not built- in the panel) to the CCFT lead
connector of the LCD panel.
2.
LVDS type panels:
Plug the signal cables direct to J14 of the controller board for VGA, SVGA or
XGA resolution Panel or J11 for SXGA resolution panel. Plug the other end of cables to the LCD
connector board.
3.
Inverter & Controller:
Plug the inverter cable to J5 of the controller board and another end to the
connector on the inverter
.
4.
Function switch & Controller:
Plug the OSD switch mount cable to J9 or J17 of the controller board
and another end to the OSD board.
5.
Jumpers & Switch:
Check all jumpers J12 (Target panel power is setting) and J4 (Target Panel
Option switch) are set correctly. Details referring the jumpers and switches setting table (in the
following section)
6.
VGA cable & Controller:
Plug the VGA cable to the connector J6 or J1 of the controller board.
7.
DIV-D Cable & Controller:
Plug the DVI-D Cable to the connector J3 or J13 of the controller board.
8.
Power supply & Controller:
Plug the DC 12V power in to the connector J2 or J8.
9.
Power on:
Switch on the controller board and panel by using the OSD switch mount
.
General:
If you use supplied cables & accessories, ensure that they are correct for the model of the panel and
the controller.
If you make your own cables & connectors, refer carefully to both the panel & inverter specifications
and the section in this manual, “Connectors, Pin outs & Jumpers” to ensure the correct pin to pin
wiring.
PC Setting:
The controller has been designed to take a very wide range of input signals however to optimize the PC’s
graphic performance we recommend choosing 60Hz vertical refresh rate – this will not cause screen
flicker
.
