33
Appendix
Operation Manual Expansion Module SO CM-E
1800.202B.0-01 Date: 02/2019
A.4 Certifications
A.4.1
CE certification
The ServoOne CM-E expansion modules conform to the requirements of the Low
Voltage Directive 2014/30/EC and the product standard EN 61800-5-1.
They thus conform to the requirements for installation in a machine or plant under the
terms of the Machinery Directive 2006/42/EC.
The expansion modules are accordingly CE marked. The CE marking on the rating plate
indicates conformity with the above directives.
A.4.2
UL certification
You will find information on the certification according to UL 61800-5-1 for the
ServoOne CM-E expansion module in the document "UL-Certification"
ID no.: 0927.01B.x. (Not yet available at the time of going to press).
A.5 Connection system
A.5.1
Connection cables for communication
This connection cable is required for cross-communication (internal system cross-
communication).
Specification:
•
Length 240 mm
•
Connector 2 x RJ10
Figure A.1 Specification type: XCOM
A.5.2
Pre-assembled DC link cable, expansion modules
This cable is used to establish a DC link connection between two expansion modules
SO CM-E.x0xx.1 "Dual" and SO CM-E.x0xx.2 "Dual End".
Scheme
Key
PE
Linie 1
Linie 2
Schnellabschaltung/
Fast Shutdown
2a
L ≤ 1,5 m
Netz/Line
X1
1
2b
X1
10
10
5
8
12
9
9
L
LL ≤≤≤≤ 1,5 m
111 5
Netz/Line
et
et
et
et
ettz/
tz/
z/
z/
z/Li
/Li
/L
/LLL
3
4
2
1
(1) DC link cable
•
Length max. 3.0 m
(as per VDE 0100)
•
DC link connector (X1)
3-pin:
DC Link +
n.c.
DC Link -
•
Cross-section 2 x 25 mm
2
•
Terminal X1 is to be tight-
ened to a tightening torque
of 2.5 Nm.
Table A.6 DC link connection between expansion module "Dual" and "Dual End"
