DAILY CONTROL AND WARNINGS
To ensure that users safely use of the electric blanket and to avoid any accident, it is recommended to pay attention
to the following:
HOW TO USE
Place the thermal blanket on the bed, making sure that the lower side reaches the height of the feet. Be careful not
to place the blanket under the pillow. For a correct use of the electric blanket, place it
over
the mattress and
under
the sheet
with angle
.
•
Temperature Adjustment: Insert the plug into an AC 220v-50hz power outlet before bedtime. Initiate the electric
blanket by pressing the power button at “
I
”: a luminous indicator will begin to signal that the equipment is operating. It
is advisable to preheat the blanket for 30-50 minutes; Then, depending on your needs, position the switch to “
I
” to
maintain a correct temperature during the night or turn off the equipment (“0”) if you want to stop the heat emission (in
this case the luminous indicator goes off).
•
The operation control device has
3
positions (0-
I-II
): set the dial to 3 (maximum temperature) for about 1 hour
before
bedtime; then set it to
I
to prevent the temperature from becoming too high and to save energy. If you wish to
leave the
blanket on during the night, place the selector switch to the Lowest position (not higher). If you want to turn it
off at
bedtime, place the selector on 0 and unplug it from the socket.
When the thermal blanket is working, the control switch must not be placed under the pillow or blankets or covered
by other objects. Do not leave the control switch near heat sources, and check that it is not overheated or damaged.
1. Heating regulator
2. Light indicator
LIST OF THE PARTS
