BATTERY INSTALLATION
HOW TO USE
1. Remove the battery cover (Battery cover lock piece) by turning
it 90 degrees to the left until it clicks into place (fi g.1) and then
pull it down (fi g.2).
2. Insert 2×AA alkaline batteries in the battery compartment as
imprinted on the back of the unit.
3. Close the battery cover by turning it 90 degrees to the right
(fi g.4) unit the cover click into place and locks (fi g.5).
This Callus Remover is designed for smoothing coarse skin on the feet and heels. Do not use this device anywhere else
on the body.
1. Wash and clean the skin and dry fully. Note: Do not use on broken or bleeding skin.
2. Make sure the Rollers Grinding Head is placed into the unit. See section of Changing the Rollers Grinding Head on
how to remove and replace head.
3. Remove the protective cover from the unit and it is ready to use.
4. Turn on the unit by pressing the safety switch sock, in the centre of the ON/OFF switch, and at the same time push
the switch up (fig.6)
5. Gently rotate (back and forth or side to side)(fig.7) on the callous/corn/hard skin area for 2-3 seconds and check.
Continue to use this method until the level of smoothness is obtained.
Warning: stop using if skin becomes sore or irritated.
6. Warning: do not use on skin for more than 2-3 seconds at a time. 15.Turn the unit off (fig.8).
7. Rinse the skin or use a wet towel to get rid of the excess
dead particles.
8. To clean this Callous Remover, please see the Cleaning
section.
9. Keep the protective cover on your unit when it is not
in use.
Summary of Contents for 2410424
Page 14: ......
