Page 8
Heating mode:
heats if the room is temperature is
below the selected temperature. Then use the
TEMP+
and
TEMP-
buttons to select the desired room temperature.
When the temperature reaches the desired temperature, the
compressor will stop, and the fan will continue to run. Heating
performance reduces if the outdoor temperature falls below
7 °C
"SPEED" Button:
Set the fan speed using the fan speed
control.
In all modes except dehumidifying mode. The fan speed can
be low, medium or high. The fan speed is indicated by the
speed of the segments on the windmill symbol on the LED
display.
TEMP+ and TEMP- buttons:
Use the + and - buttons to select the desired room
temperature. The temperature can be set to any temperature
from 16 °C to 31 °C. Selecting a lower temperature whilst
heating, or a higher temperature whilst cooling will reduce
power consumption.
SWING button:
Press the "SWING" button to turn the
oscillation of the louvres on or off.
If the
"WATER FULL"
indicator lights, the condensate water
tank is full. This should only happen very rarely, as most of
the water collected is evaporated and sent down the exhaust
air tube.
To empty the water, switch the unit off by pressing the
ON/OFF button, wait for three minutes, and then disconnect
from the mains supply. Place a drainage pan underneath the
drain outlet plug (an the bottom of the unit, at the back in the
centre). Withdraw the bung, and allow the water to drain into
the drainage pan. Replace the bung, and reconnect the unit to
the mains supply.
