12
WATER DRAINAGE
When used in high humidity areas (over 60% humidity) , continuous operation may be interrupted
due to excessive dehumidification producing excessive water,
This unit has a special built in
facility to avoid the unit stopping operation.
The unique design of this unit allows you to connect
a water drain pipe to the upper water release port for extra convenience and ease of use. This will
allow the machine to drain the water automatically.
When this feature is desired ,connect the 3 metre water pipe to the automatic water releasing port.
The water pipe will drain water out a window or suitable drainage area or exit point. Please ensure
the water drain hose is no higher than 1.5 meters from base of unit. Ensure the drain pipe is not
bent or twisted. IF THIS FEATURE IS NOT REQUIRED (due to lower humidity) please ensure the
plastic screw lid is tightly secured to upper drainage port,
NOTE If the water release port and water release pump are NOT used during periods of high humidity,
water will collect in a water container at the bottom of the unit. When the water container is full, the
compressor will stop but the fan will continue to run.
When the water container is full, the unit will display ‘
’ on the control panel until the tank is emptied.
To resume operation, empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place the drain pan accessory under the drainage port at the back of the unit.
3. Remove the rubber plug from the drain hole. The condensate water will drain out automatically.
When the drain pan is full, replace the rubber plug into the drainage hole to stop the water flow.
Empty the drain pan. Repeat until all the water is emptied.
4. Once the water container has been emptied, replace the rubber plug into the drain hole firmly. Do not
allow the water to drip continuously into the drain pan, as it might easily overflow.
Automatic
freeing
port
Automatic
freeing
port
Drain
Drain Port
