OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS (cont.)
1. Interior Light
2. “+” - Temperature Up - temperature will increase 1 degree
3. Temperature Display Window
4. Fahrenheit and Celsius indicator LEDs
5. “-“ - Temperature Down - temperature will decrease 1 degree
6. Fahrenheit & Celsius Selector: select your choice of temperature scale
7. Power ON/OFF: once to turn on the appliance, press for 3 seconds to turn it off.
• It is normal that the preset temperature and display temperatures are different when using for the
first time. It will take approximately 1 hour for the unit to stabilize the temperature. Fill the Beverage
Centre with your choice of wine bottles and beverages. Allow 2-3 hours of operation before they
reach the desired temperature.
• The temperatures may fluctuate depending on whether the interior light is ON or OFF or the bottles
are located on the upper/middle/lower section.
• If the appliance is powered off suddenly, wait for 5 minutes before turning the unit on. It will return to
the settings applied, the temperature setting is with automatic memory function.
RECOMMENDED TEMPERATURES FOR CHILLING WINE
Red Wines: 59-66°F (15-18°C)
White Wines 46-59°F (8-15°C)
SHELF
• To avoid the damage of door sealing, please open the door fully when you slide out the shelves.
• When taking wine bottles out, you can pull out the shelf by 1/3. Our product is designed with shelf
holder to prevent the shelf pull out fully and fall out of the cabinet by accident.
• If need to take off the shelf from cabinet, you can pull out the shelf to the shelf holder
position, then lift up the shelf to remove the shelf. (See figure below)
You can adjust the temperature by using the digital display for each zone.
4
5
DOOR REVERSAL
‘A’ Glass door, ‘B’ Hexagonal wrench
1. Fig:1 - Remove the screws on lower hinge with the hexagonal wrench. Please hold the door to avoid
the door drop down after loosening the screws.
2. Fig:2 - Remove the door in position ’1’, then take out the door in position ‘2’. Fig:3 shows the door
is taken out.
3. Fig:4 - Tilt the door and insert to the top like ‘1’ shows, then move the door levelly to make it in the
same level with the cabinet ‘3’. Fig:5 before tighten the bottom screws, make sure the door is in the
same level with the cabinet.
4. Fig 6: Door reverse is finished.
INSTALLATION (cont.)
