12
Programming sequence mode 2
1) For an audible signal connect the
motor to the PIX.
2) Turn on the Tx and set the throttle
to EMF-brake position (back
position).
3) Connect the battery.
4) Wait 2 sec., or until
ε
ε
ε
beeps.
5) Push the button.
6)
Ε
Ε
Ε
. . . ε . . . εε
7) Set the throttle to full speed (front
position).
8)
Ε
Ε
Ε
9) Set the throttle to brake (back
position).
10)
Ε
Ε
Ε
11) Set the throttle to motor off (middle
position) optional.
12)
Ε
Ε
Ε
13) Monitoring output
εε.
14) Ready - Disconnect the battery..
6.3 The Sports Plane / Boat Mode
(Mode 3)
All required properties for electric powered
sports planes or boats are preadjusted in
this mode.
•
The EMF-brake is disabled.
•
The under voltage cut off is disabled.
Instead a motor slow down is activated
when the battery reaches the discharge
voltage.
•
The over temperature cut off and the
over current limitation are activated to
cut off the motor at over load
conditions.
Programming sequence mode 3
1)
For an audible signal connect the
motor to the PIX.
2)
Turn on the Tx and set the throttle
to EMF-brake position (back
position).
3)
Connect the battery.
4)
Wait 2 sec., or until
ε
ε
ε
beeps.
5)
Push the button.
6)
Ε
Ε
Ε
. . . ε . . . εε . . . ε
εε
7)
Set the throttle to full speed (front
position).
8)
Ε
Ε
Ε
9)
Monitoring output
εεε.
10) Ready - Disconnect the battery
6.4 Reverse Motor Rotation (Mode 7)
The motor rotation will be reversed by
changing any 2 motor cables or by
programming mode 7. This mode does not
change any other features programmed
before. Program like Mode 3 but wait on 7
signals.
6.5 Lipo Mode (Mode 9)
Programming this mode will toggle the
setting of the discharge voltage between
0.7-0.8V per NiCd/NiMH cell and 2.7-3V
per Lipo cells.
This mode does not change any other
features programmed before. Program like
Mode 3 but wait on 9 signals.
To avoid misunderstandings the start up
signal changes to
ε
ε
ε
ε
ε
ε
when the
LiPo-Mode is active.
7.
Troubleshooting
Unexpected motor cut off:
•
Strong interference with the Rx.
/
Install the Rx and the antenna with
more distance from ESC and motor.
Use torodial core KONTRONIK #9700.
•
Over temperature:
/
Improve the cooling of the speed
control.
•
Interruption of the power supply (loose
connection):
/
Only use high quality connectors as
KONTRONIK silver connector #9010
or gold connectors.
