Kontron IP Network Server NSC2U
December 2009
Product Guide, rev. 1.4
121
5. Remove the riser card assembly. For instructions see
PCI Riser Card Assembly” on page 53
.
6. Insert the tip of a small flat bladed screwdriver, or better yet an equivalent non-
metallic tool, under the tab in the plastic retainer. Gently push down on the
screwdriver to lift the battery.
7. Remove the battery from its socket.
8. Dispose of the battery according to local ordinance.
9. Remove the new lithium battery from its package, and, being careful to observe the
correct polarity, insert it in the battery socket.
10. Re-install the processor air duct, riser card assembly, and the chassis cover.
11. Run Setup to restore the configuration settings to the RTC.
Figure 105. Replacing the Battery
TS00030
8
