mITX-SKL-S/H110 – Rev. 1.1
www.kontron.com
// 12
3/
Installation procedure
3.1.
Packing Check List
The mITX-SKL-S/H110 package includes the following basic items accompany with this manual.
One main board
One IO shield
If any of these items are damaged or missed, please contact your vendor and save all packing materials for future
replacement and maintenance.
Note: The above packing list is for standard single box packing only.
3.2.
Installing the Board
ESD Sensitive Device!
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry.
•
Wear ESD-protective clothing and shoes
•
Wear an ESD-preventive wrist strap attached to a good earth ground
•
Check the resistance value of the wrist strap periodically (OK: 1 M
Ω
to 10 M
Ω
)
•
Transport and store the board in its antistatic bag
•
Handle the board at an approved ESD workstation
•
Handle the board only by the edges
To get the board running follow these steps:
1.
Turn off the Power Supply
Make sure to use a standard ATX PSU, suitable cable kit and PS_ON#.
2.
Connecting Interfaces
Insert all external cables for hard disk, keyboard etc. A monitor must be connected in order to change BIOS
settings.
3.
Connect PSU
Connect PSU to the board by the ATX+12 V 4-pin connector and also the ATX 20-pin connector (ATX PWR 20-pin
+ 4-pin (Internal Input Power)) to the I/O power jack.
4.
Mounting the board in chassis
When mounting the board to chassis etc. please notice that the board contains components
on both sides of the PCB which can easily be damaged if board is handled without
reasonable care. A damaged component can result in malfunction or no function at all.
When fixing the Motherboard on a chassis it is recommended to use screws with integrated washer and a
diameter of
>
7 mm. Do not use washers with teeth, as they can damage the PCB and cause short circuits.
5.
BIOS Setup
Enter the BIOS setup by pressing the <F2> key during boot up.
Enter “Exit Menu” and Load Setup Defaults.
Refer to the “BIOS Configuration / Setup“ section of this manual for details on BIOS setup.
To clear all BIOS settings, including Password protection, activate “Load Default BIOS
Settings” Jumper for more than
10 sec (without power connected).
Summary of Contents for mITX-SKL-S-H110
