KBox A-150-HSW - Rev. 1.0
// 32
Figure 16: DIN Rail Mounting Options
9.2.
Power Connector
The KBox A-150-HSW is connected by the Input power connector on the front panel to a DC power source via a DC
power supply wiring consisiting of the Phoenix power mating connector (3 pin Phoenix PSC 1,5/ 3-F ) delivered with
the KBox A-150-HSW and the assembled wires. For information on how to assemble the wires, see Chapter 9.2.1.
Figure 17: Phoenix Power Mating Connector
1
3-pin Phoenix plug terminal
2
Cover over the slotted pan head screws
3
Location for inserting the functional earth wire
4
Location for inserting the 0 V wire
5
Location for inserting the 24 V wire
9.2.1.
Wiring the DC Mating Power Connector
To wire the supplied 3 pin Phoenix PSC 1,5/ 3-F power mating connector, following the step below.
1.
Cut three (1 mm
2
) AWG18 isolated wires to the required length and strip each end 5 mm – 7 mm.
2.
Twist the striped wire-ends and provide them with ferrules.
3.
Access the slotted pan head screws by opening the Phoenix Power Mating Connector cover (Figure 17, pos. 2).
1
2
4
5
3