KBox A-150-HSW - Rev. 1.0
// 31
9/
Installation Instructions
9.1.
DIN Rail Mounting
The KBox A-150-HSW is a rail mount PC box designed for use in a DIN rail enclosure or housing by attaching a DIN rail
mounting clamp. The DIN rail mounting clamp can be attached on:
Top side of the chassis
Rear side of the chassis
The position and direction of the clamp decides the orientation of the product within the DIN rail enclosure or housing.
When deciding on the KBoxA-150-HSW’s orientation consider access to the front panel and to the external HDD/SDD
drive bay, if available.
To attach the DIN Rail retaining clamp, follow the steps below:
1.
Make sure that the DIN Rail retaining clamp is in the upper position, for the required mounting option.
Figure 14: DIN Rail Position
2.
Fasten the DIN rail mounting clamp firmly to the chassis using two M4x6 (Max. length) counter sunk screws.
Figure 15: DIN Rail Clamp Screw Dimensions
3.
Clip the top of the DIN rail mounting clamp in to the DIN rail and push the bottom of the DIN rail firmly until it
clamps on to the bottom of the DIN rail.
Mounting Direction, Clamp always in the
lower position
