Installation
CP930
Page 3 - 4
© 2003 Kontron Modular Computers GmbH
ID 26683, Rev. 01
3.1.2
Installation Procedures for use in CompactPCI Slot
To install the board proceed as follows:
1. Ensure that the safety requirements indicated above are observed (no Hotswap).
2. Ensure that the board is properly configured for operation before installing.
3. To install the board perform the following:
1. Prior to installation of the board disengage the insertion/extraction handle by first un-
locking the handle and pressing it down.
2. Insert the board into an appropriate slot, and, using the insertion/extraction handle, en-
sure that it is properly seated in the backplane. (Front panel is flush with the rack front;
the insertion/extraction handle is locked.)
4. Fasten the front panel retaining screws.
5. Connect external interfacing cables to the board as required.
6. Ensure that the interfacing cables are properly secured.
3.1.3
Removal Procedures for use in CompactPCI Slot
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated above are observed.
2. Disconnect any interfacing cables that may be connected to the board.
3. Loosen both of the front panel retaining screws.
4. To remove the board from the backplane perform the following:
1. Unlock the insertion/extraction handle by pressing down on the grey locking mecha-
nism in the middle of the handle. (This should be achievable with a minimum of force.
If necessary lift the handle up slightly while pressing down on the grey locking mech-
anism.)
2. Disengage the board from the backplane by pressing down on the insertion/extraction
handle and pull the board out of the slot ensuring that the board does not make contact
with adjacent boards. (If the handle does not move, it is not unlocked. Repeat the un-
locking procedure above and try again. Do not use force!)
Warning!
Failure to comply with the instruction below may cause damage to the board or
result in improper system operation.
Note...
Care must be taken when applying the procedures below to ensure that when
the board is inserted it is not damaged through contact with other boards in the
system.
Warning!
Care must be taken when applying the procedures below to ensure that
when the board is removed it is not damaged through contact with other
boards in the system.
