D R A F T — F O R I N
T E R N A L U S E O N L Y
25
www.kontron.com
User Guide
CP6105X
4.3 Board Installation
The CP6105X is designed for use in a peripheral slot.
4.3.1 Board Insertion
Prior to following the steps below, ensure that the safety requirements are met.
Note:
The CP6105X is not hot swap capable.
To insert the CP6105X in a system, proceed as follows:
1.
Ensure that no power is applied to the system before proceeding.
2.
Ensure that the board ejection handles are open.
3.
Insert the board into the slot designated until it makes contact with the backplane connec-
tors.
4.
Using the ejector handles, engage the board with the backplane. When the ejector handles
are closed, the board is engaged.
5.
Fasten the front panel retaining screws.
6.
Connect all external interfacing cables to the board as required.
4.3.2 Board Removal
Prior to following the steps below, ensure that the safety requirements are met. When removing a
board from the system, particular attention must be paid to the components that may be hot, such as
heat sink, etc.
Note:
The CP6105X is not hot swap capable.
To remove the CP6105X from a system, proceed as follows:
1.
Ensure that no power is applied to the system before proceeding.
2.
Unlock the board ejection handles by pressing their release buttons.
3.
Disconnect any interfacing cables that may be connected to the board.
4.
Unscrew the front panel retaining screws.
5.
Using the ejector handles, disengage the board from the backplane and remove it from the
system.
6.
Dispose of the board as required.
