Kontron CP6001-R3, User Manual

Page: 25 / 30

CP6001-R3 Introduction
ID 1027-2047, Rev. 1.0 Page 1 - 9
Interfaces
CompactPCI Compliant with CompactPCI Specification PICMG 2.0 R3.0:
•
System master operation
•
32-bit / 66 MHz PCI/PCI-X master interface
•
3.3V or 5V signaling levels (universal signaling support)
Compliant with Packet Switching Specification PICMG 2.16 R1.0
When the CP6001-R3 is operated in a peripheral slot, the CompactPCI bus is
electrically isolated (passive mode).
Rear I/O The following interfaces are routed to the rear I/O connector J3, J4 and J5:
•
COM1 and COM2 (RS-232 and RS-422 signaling); no buffer on the rear
I/O module is necessary
•
4 x USB 2.0
•
CRT VGA, DVI, HDMI
•
PS/2 (Mouse / Keyboard)
•
2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)
•
4 x SATA
•
CCPMC rear I/O
•
HDA digital output (requires external codec)
•
Fan control
•
Speaker
Hot Swap Compatible
The CP6001-R3 supports System Master hot swap functionality and applica-
tion dependent hot swap functionality when used in a peripheral slot.
When used as a System Master the CP6001-R3 supports individual clocks for
each slot and ENUM signal handling is in compliance with the PICMG 2.1 Hot
Swap Specification.
VGA Built-in Intel 3D Graphics accelerator for enhanced graphics performance.
• Supports resolutions of up to 2048 x 1536 at a 75 Hz refresh rate
• Hardware motion compensation for software MPEG2 decoding
• Dynamic Video Memory Technology (DVMT3.0)
Gigabit Ethernet Two 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on two Intel® 82573L Ethernet PCI Express bus controllers.
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto MDI-X)
Cabling requirement: Category 5, UTP, four-pair cabling
USB Four USB 2.0 ports supporting UHCI and EHCI on the rear I/O interface
Serial Two 16C550-compatible UARTs on the rear I/O interface, one for RS-232 and
one for RS-422 signaling.
Table 1-1: CP6001-R3 Main Specifications (Continued)
CP6001-R3 SPECIFICATIONS