Kontron AM4100, User Manual

Page: 63 / 150

AM4100 Installation
ID 36126, Rev. 2.0 Page 3 - 7
P R E L I M I N A R Y
5. When the handle is fully retracted, the board is engaged and the following steps occur:
1. The BLUE HS LED turns on.
When the carrier recognizes that the AM4100 is fully seated, it enables the man-
agement power for the AM4100 and the BLUE HS LED turns on.
2. Long blinks of the BLUE HS LED
If the carrier IPMI controller detects the AM4100, it sends a command to the
AM4100 to perform long blinks of the BLUE HS LED.
3. The BLUE HS LED turns off.
The Intelligent Platform Management Controller on the carrier reads the Module
Current Requirements record and the AMC Point-to-Point Connectivity record. If
the Module FRU information is valid and the carrier can provide the necessary pay-
load power, the BLUE HS LED will be turned off. If the module FRU information is
invalid or the carrier cannot provide the necessary payload power, the hot swap
process is stopped and the BLUE HS LED keeps blinking. Should this problem oc-
cur, please contact Kontron’s Technical Support.
4. Short blinks of the Module Management LEDs and the User-Specific LEDs
The carrier enables the payload power for the AM4100, and the Module Manage-
ment LEDs and the User-Specific LEDs emit a short blink.
4. The AM4100 is now ready for operation. For operation of the AM4100, refer to appropri-
ate AM4100-specific software, application, and system documentation.
3.5 Software Installation
The installation of the Ethernet and all other onboard peripheral drivers is described in detail in
the relevant Driver Kit files.
Installation of an operating system is a function of the OS software and is not addressed in this
manual. Refer to the appropriate OS software documentation for installation.