ADD2-DVI-Dual
KTD-00714-F
Public User Manual
Date: 2008-11-25
Page
9 of 9
Jumper Description (unsupported)
The Jumpers (only available on the ADD2-DVI-Dual-Internal) are used to configure one or both DVI outputs
for TMDS or PanelLink panels where DDC (EDID codes) are not integrated. By use of jumpers it is possible
to connect onboard EEPROM to the DDC channel and to select panel to be always connected. The panel
specific EDID code must be loaded to the relevant EEPROM.
Signal Name
pin
pin
Signal Name
DDCCLKU7 1 2 DDCCLK1
DDCDATU7 3 4 DDCDAT1
ALWAYSON1 5 6 HOTPLUG1
DDCCLKU8 7 8 DDCCLK2
DDCDATU8 9
10 DDCDAT2
ALWAYSON2 11 12 HOTPLUG2
When mounted jumpers 1-2, 3-4 and 5-6 then EEPROM (U7) then DVI-SIL1 will be configured for
TMDS/PanelLink displays (no integrated DDC and HotPlug).
Similar when mounted jumper 7-8, 9-10 and 11-12 then EEPROM (U8) then DVI-SIL2 will be configured for
TMDS/PanelLink displays.
Installation Guide
Plug in the ADD2-DVI card to the PCIe-x16 slot (nearest CPU)
Optionally fix the 820952 ADD2-DVI-Dual directly to DVI cut out hole in the chassis or mount the included
DVI Full Height B two screws (bracket/screws are not included in the revision below 820952-R13).
Optionally fix the 820955 ADD2-DVI-Dual-Internal to bracket or chassis via the mounting hole.
Optionally connect 821524 (300mm cable) or 1022-2966 (150mm cable) to the ADD2-DVI card
Optionally mount the DVI connector adapters in the chassis
For the 986LCD-M, BIOS 986LCD18 or above and for the KT965, BIOS KT965009 or above:
Boot and enter BIOS
Select Chipset > North Bridge Configuration > Video Function Configuration >
Boot Type = [CRT+EFP] or [EFP] (if boot on DVI panel no.1 is requested)
SDVO = [DVI – D]
Select Exit menu.
Hint: Using also Secure CMOS = [Enabled] will make sure that Windows will not change Boot Type in BIOS.
Save Changes and Exit.
Boot into OS and load Intel Graphics Media Driver. For Windows install version 6.14.10.4859
(win2K_xp1431.exe) or newer.
Select output to Digital Monitor (DVI panel no.1) and optionally Digital Monitor 2 (DVI panel no.2).
Electrical Specification
Power consumption:
The +5V available on the DVI connectors can deliver minimum 55mA continuously and 1A peak. The output
is protected by thermal shutdown circuit.
3.3V 5W/2.5W max. (Dual/Single).
12V 1W max.
Operating temperature:
0-60ºC
