AL i.MX8M Mini - Rev. 2.0
www.kontron-electronics.de
// 31
Accessing Components
This chapter contains important information that users must read before accessing components. Follow these procedures
properly when accessing or installing component to extend the system.
The AL i.MX8M Mini is factory configured to meet customer requirements. Kontron Electronics does
not recommend opening the system as this may cause damage to internal components.
There is a protection label on the AL i.MX8M Mini.
If the product is opened within the warranty period, the warranty is lost.
The installation/removal of system components may only be performed by a qualified person. Observe
the “General Safety Instructions for IT
-
Equipment” and the “installation instructions” contained within
this user guide.
ESD Sensitive
Follow the safety instructions for components that are sensitive to electrostatic discharge (ESD). Failure
to observe this warning notice may result in damage to the product or/and internal components.
Because of the
limited predetermined lifespan of expansion devices, Kontron Electronics recommends
checking the condition of installed expansion devices regularly and to pay attention to the
manufacturer specifications for lifespan.
Accessing External Components
4.1.1.
MicroSD Card Slot
The AL i.MX8M Mini supports a removable microSD card.
To remove/install a removable microSD card, perform the following steps:
1.
Press the microSD card on the right-hand side of the AL i.MX8M Mini to remove a microSD card out of the slot.
2.
The microSD card automatically slides out a bit for removal.
3.
Slide in the microSD card, if needed. Take care of the correct position.
Accessing Internal Components
4.2.1.
Opening the Chassis
The AL i.MX8M Mini is factory configured to meet customer requirements. Kontron Electronics does
not recommend opening the system as this may cause damage to internal components.
There is a protection label on the AL i.MX8M Mini.
If the product is opened within the warranty period, the warranty is lost.
