Fig. 12
1. Use a 13 mm wrench to remove the Guard Screws that secure the flywheel Guard (Fig 11).
2. Remove the Guard Screws that secure the Flywheel and Belt Guard.
3. Disconnect the return spring.
4. Pull the Rack out and grease the Rack Teeth, top side of the Rack and the Pinion (Fig.12).
5. Push the Rack back in and reinstall the Return Spring when finished greasing.
6. Reinstall the Guards.
Guard
Screws
flywheel
Guard
Guard
Screws
Belt Guard
Pinion
Rack Teeth
Fig. 11
REGULAR MAINTENANCE CHECKLIST
9
This manual compliance! You can find a list of service center addresses on the website of exclusive importer:
www.ks-power.de/en
Potential faults and troubleshooting methods can be found in the full version of the manual.
Potential faults and troubleshooting methods can be found in the full version of the manual.
WARRANTY SERVICE TERMS
10
The international manufacturer warranty is 1 year. The warranty period starts from the date of purchase.
In cases when warranty period is longer than 1 year according to local legislation please contact your local
dealer. The Seller which sells the product is responsible for granting the warranty. Please contact the Seller for
warranty. Within the warranty period, if the product fails because of defects in the production process, it will
be exchanged on the same product or repaired.
The warranty card should be kept throughout the warranty period. In case of warranty card loss, a second
one will not be provided. The customer must provide the warranty card and buyer`s check during request
for repair or exchange. Otherwise, the warranty service will not be provided. The warranty card, attached to
the product during sale, should be correctly and fully completed by the retailer and customer, signed and
stamped. In other cases, warranty is not considered as valid.
Provide clean product to the service center. Parts, that must be replaced, are the property of the service
center.
PROCEDURE
Before each use
Every 5 hours
Every 25 hours
Every 150 hours
Check general equipment
condition
Cleaning the rail from
debris
Check belt
KS 8TKE 52/35
Check the condition of the
electrical cord
Grease rack
Clean motor exterior and
cooling fins
Motor oil changing
KS 7THE 52/30
www.ks-power.de/en
|
8
Summary of Contents for KS 7THE 52/30
Page 10: ......
