Könner & Söhnen KS 12THE V 65/40, Owner'S Manual

Page: 7 / 14

LOG SPLITTER KS 8THE V 55/40 ASSEMBLY
5
STEP 1: STEP 1:
INSTALL THE WHEEL ON BOTH SIDES INSTALL THE WHEEL ON BOTH SIDES
STEP 2: INSTALL THE OPERATING LEVER STEP 2: INSTALL THE OPERATING LEVER
ASSEMBLY ON BOTH SIDES ASSEMBLY ON BOTH SIDES
Pull out control handle pin (h) to release lock (a). Then in-
sert the operating lever assembly and make sure that it has
reached its intended end position (g). Now, latch the oper-
ating lever assembly by lock (a) and control handle pin (h).
Perform the same procedure for the other control handle.
STEP STEP 3 3:: FIX THE PROTECTION BAR TO THE OPERATING LEVER ASSEMBLY FIX THE PROTECTION BAR TO THE OPERATING LEVER ASSEMBLY
STEP STEP 4 4:: INSTALL THE LOG TRAY TO THE MACHINES ON BOTH SIDES INSTALL THE LOG TRAY TO THE MACHINES ON BOTH SIDES
LOG SPLITTER KS 12THE V 65/40 ASSEMBLY AND PREPARATION
6
Unpacking this log splitter requires at least two persons. To place the log splitter on the floor, proceed step by step as
described below. Ensure that block (B) supports the log splitter box (A) at a point above its middle. The other end of block
(B) should rest on a fixed object such as a wall. Fasten wedge (C) under the lifted box to prevent the latter from slipping
off. After that, you can remove the packing carton from the log splitter.
konner-sohnen.com
| 6