■
How to Use the IR Extender Accessory
The IR extender connects to the transmitter through its own special connector
plug. The extender emits an IR signal can control your A/V equipment with
the remote signal. To use the IR extender, follow the instructions below:
(1) Plug the IR extender into the 2.5mm phone jack of transmitter’s rear
panel.
(2) Connect the infrared cable at the left of the transmitter and put one of the
LED on the infrared receiver of the A/V source. You have 3 more LED’s
at you disposal to control 3 additional A/V appliances. More the LED in
order to find the most appropriate spot.
DVD/VCR/SAT
Infrared receiver
Fig-5
(3) Position the receiver so that your remote control signal can strike the IR
window on the bottom front of the unit. To use your remote control, point
it at the front of the receiver.
-15-
G. Troubleshooting, Care and maintenance
Please read this owner's manual carefully and follow the steps described in it.
If you still have difficulties, consult the following table. It will guide you though
the most common problems and their solutions.
Note:
Clean the outside plastic packaging with a soft cloth lightly moistened
with mild soap and water. Never use any abrasive scouring powder
or solvent.
-16-
Problem
Possible solutions
No picture or sound
•
Check all cable connections.
•
Make sure power plugs are pushed all the way
in.
•
Check power switches on the remote TV and
Video source. (VCR, laser disc player, satellite
receiver, ect. )
•
Check the power on/off switches on the
transmitter and receiver.
Interference:
Noisy picture or audio
•
Adjust receiver and transmitter antenna
orientation. ( see
section on "Orienting Units for Optimum
Performance"
in this manual )
•
Select a different channel by pushing the
channel
selector button on both transmitter and receiver
so that the channels match.
•
If using a microwave oven, turn it off.
•
Remove microwave oven from path between
transmitter and receiver.
Remote control
extender does
not work
•
Check the path between the transmitter and the
audio/video source and clear any obstructions.
•
Check to see if the IR window on the bottom
front of the transmitter is blocked.
•
Make sure IR extender is properly rotated in the
A/V equipment you wish to control. (see section
on "Using the Remote Control Feature" in this
manual)
•
Adjust remote control antennas. (see section on
"Orienting Units for Optimum Performance" in
this manual )
