Wall Mounting:
1. Remove the back plate.
2. Mount the back plate to the desired position on the wall.
3. Clip the unit to the back plate.
4. Secure the alarm to the back plate by fastening the screw on the
bottom.
Remote control:
The remote control uses 3x LR44 batteries (included). If the red
LED indicator on the remote control does not light up when the
‘ARM’ or ‘DISARM’ buttons are pressed, then the batteries need to
be replaced.
Program alarm:
1. Set the switches (11) of the remote control to the desired code
and remove the batteries from the alarm. Then wait at least 30
seconds for the alarm to reset.
2. Aim, immediately after inserting the batteries, the remote control
at the alarm and press the ‘ARM’ button. The Alarm LED will flash
once to indicate that it has learnt the code of the remote control.
NOTE:
the alarm must be programmed again with the remote
control each time the batteries are replaced.
Operation:
Aim, when leaving the protected area, the remote control at the
alarm and press the ‘ARM’ button. A confirmation tone will indicate
that the alarm is armed and you have 30 seconds to leave the area.
After this time, if motion is detected, the alarm will sound.
Aim, when entering the protected area, the remote control at the
alarm and press the ‘DISARM’ button. There is a short beep, when
entering the area, to indicate that motion has been detected. You
have 4 seconds delay to disarm the alarm.
