Battery installation:
Alarm:
1. The battery compartment is accessed
from the rear of the alarm by removing the
screws of the mounting bracket.
2. Insert 4x C size batteries (not included)
according the correct polarity
(see figure C)
3. When the batteries are inserted the
alarm will beep very loud to indicate that
the batteries are properly installed.
4. Replace the mounting bracket and fix it
with the screws. The battery LED indicator
will light when the batteries are LOW and
need to be replaced.
Remote control:
The remote control uses 3x LR44 batteries (included). If the red
LED indicator on the remote control does not light up when the
‘ARM’ or ‘DISARM’ buttons are pressed, then the batteries need to
be replaced.
Program alarm:
1. Set the switches (12) of the remote control to the desired code
and remove the batteries from the alarm. Then wait at least 30
seconds for the alarm to reset.
2. Aim, immediately after inserting the batteries, the remote control
at the alarm and press the ‘ARM’ button. The Alarm LED will flash
once to indicate that it has learnt the code of the remote control.
NOTE:
the alarm must be programmed again with the remote
control each time the batteries are replaced.
