König Electronic IPD-SPEAKER40, Manual

Page: 2 / 46

2
ENGLISH
After unpacking:
After unpacking you should fi rst check that the contents are complete. In addition to this
introduction there should be:
1 IPD-SPEAKER40 Mini 2.1 Stereo Sound System
1 audio
cable
1 power source wire
1 manual
1 remote
control
1 battery CR2025
1 iPod holder
Assembly and operation
Assembly and operation of the IPD-SPEAKER40 are very easy to do. Please connect all
components only when they are switched off.
• Volume is controlled with the keys
5
.
• Use the audio cable to connect your sound system at the input jack
qd
or
qf
to a respective
sound source.
• You must check your power voltage before operation the unit.
• Connect he power cable to connector
qs
of your sound system. Ready.
• The sound system is switched on/off with the ON/OFF key
qa
on the rear panel. The LED
6
lights green.
• The switches TREBLE
4
and BASS
1
allow adjusting higher and lower frequency ranges.
While the setting is made the LED is lighted green. Any settings are lost after the unit is
switched off.
Advice on location, care and safety
• Connect the audio input to the line-out, non amplifi ed output. Avoid connection to the
speaker out sound system jack of your sound source. The amplifi ed signal from the
speaker out sound system may cause unnecessary distortion and may damage the
speaker-circuit.
• To connect your sound-system with power supply system, please make sure to have a
socket close to your sound-system.
• If the sound-system is not in use for a longer period of time, be sure that your system is
disconnected from mains power.
• Do not use alcohol, benzene, thinner or acids to clean the cabinet.
• Do not place your sound-system near radiators, air conditioning or radio-controlled
systems.
• Avoid leaving the sound-system in permanent strain such as direct sunlight, extreme moist
or dryness, exceptional cold or heat, mechanical vibrations or shock.
• Do not open the cabinet, contact qualifi ed personnel only.
• For service staff: never open cabinet, when speaker system is connected to 230V AC
power supply system.