-42080.000.55-
-03.80.822.00- 2/04
DJ-Table »Suspensor« 42080
4. Adjusting the DJ-Table
The spring resistance
There are four of ten possible spring elements pre-installed per supporting plate, this equals a
loading capacity of 10 kg.
Installing additional springs:
- Slide the spring 11 over threaded rod 12. Stick both from above through the holes 13 in the
table frame and the supporting plate.
- Press rod 16 as far as possible downwards against the force of the spring.
- Screw the M6 14 nut and the ø12 15 washer onto the threading by hand.
- Then screw down with the two wrenches 17 and 18 until the upper wrench slides over the
hexagon head.
When all ten spring elements have been installed, the load-bearing of one supporting plate is 25 kg.
The Height
The legs 22 are extendable and can be locked into eight positions 23. At a distance of 50 mm
each, this adds up to 350 mm.
- Loosen the screws 21
- Extend leg tube 20
- Retighten the screw 21
IMPORTANT: The shaft end of the screw 25 has to project into one of the eight holes drilled
in the leg tube. This is absolutely necessary for the stability.
Tip: The shaft end of the screw 25 can dip into the leg tube when another hole 24 is situated
beneath the cap 26.
The Stability
Any unevenness in the floor can be neutralized by twisting the compensation screws 19.
The legs should be adjusted such that the supporting plates are in a horizontal position.
The shaft ends of the screws have to project into the leg tube.
11
14
15
12
13
17
10
19
20
21
22
25
24
26
23
18
16
Pre-installed
50 mm
60 mm
Correct
Incorrect
Note: The item numbers do not match the spare part
order numbers.
Page 3
